Show us your 3D printed sex toys

[Joanne]

OMG, those look incredible and I think you made a good choice annealing them and then coating them to seal the surfaces. I have no doubt that they will feel amazing and with three sizes you have lots of choices when you play.

[eblob]

This one is a test setup. After all this years I'm still searching for the perfect anal toy. I took my favorite wooden pug recreated it as a 3D print and added 4 electrodes. I intend to make some test drives next week to find out if they hit the right spots.

[Joanne]

That is a very clever design, I look forward to hearing just how it performed when you test it out.

[eblob]

First test show, that it is effective. On maximum power quite painful and can force small ejaculations. Under normal conditions quite pleasant. Maybe not yet the perfect position for prostate stimulation, but closer then my other efforts.

[Joanne]

I'm impressed, not bad for a first try at the design, is that three or four wires coming out of the bottom?

I am trying to understand the current flow that it creates.

[eblob]

Thx, It was my first real project on Fusion360. due to you I tried it and will use it a lot. At least for the first year. I think its only free the first year.
4 wires so I can try different combinations. Most of the time i used the outer ones on one channel and the inner ones on the other.

[Joanne]

I am glad that you gave Fusion360 a go, it is a fantastic piece of software and thanks for the explanation of the wiring, very interesting.

[JasonGraham]

Now I want to buy a 3d printer for myself.

[Joanne]

Now I want to buy a 3d printer for myself.

They are amazing machines and so much fun to learn to use.

[bamaswitch]

I can't wait to try some of these great ideas, ya'll have! I bought a 3D printer about a year ago and have never had the chance to use it. My work level went crazy when everyone else's dropped off. This looks like a LOT of fun.