New Project - Gas Mask Bits And Bobs

[Joanne]

With the Coronavirus keeping us in full lockdown in the UK I am looking for some kinky DIY projects to keep my fingers busy.

I have bought two gas masks, one a Russian one and a UK S10 respirator (which Stunt Cock loves as he used them in the military) and I am going to design some attachments for them.

I have already designed a cunt sniffer box which is also a bipolar e-stim electrode you can see it here - Joanne's Cunt Sniffer Electrode.

So has anyone got any other suggestions for DIY gas mask mods that I can design for printing on my 3D printer?

The gasm masks I have coming

S10mask.jpg (24.3 KiB) Viewed 4374 times

[Joanne]

Anyone like breath play and sniff play too? I have designed a air flow restrictor with a NATO40 thread (that was a pain in the ass to model). It has four settings, 6,8,10 and 12mm diameter flow holes.

It also unscrews to provide a compartment that can be used for sniffing play, whether that be cotton wool and poppers, a used condom or maybe painties. Use your imagination for other options.

Having a NATO40 thread means it is compatible with virtually every gas mask with a 40mm thread.

Gas Mask Flow Restrictor V1.0

gasmaskflowrestrictor.jpg (104.72 KiB) Viewed 4369 times

[lawman]

Put me on the list for the restrictor/sniff box. This is awesome! I have an Israeli and the UK FM12 which is almost identical to the S10.

[Joanne]

Put me on the list for the restrictor/sniff box. This is awesome! I have an Israeli and the UK FM12 which is almost identical to the S10.

The Avon FM12 is a fantastic little respirator, I may have to make myself something with flashy lights on mine when I receive it. That project of yours really interests me. I am sure you would enjoy the breath restrictor.

[Joanne]

Looking at this design my Ender 3 could do a good job or it but cleaning up the supports would be a nightmare. I may look into getting hold of an SLA 3D Printer in order to be able to do the design justice.

Just for info this is what the supports would look like on an SLA printer when printing the three components.

Supports

gasmaskflowrestrictor2.jpg (61.42 KiB) Viewed 4356 times